19. Wrap the Butterfly Cable (89) around a 3 1/2Ó Pulley
(82) as shown. Attach the Pulley and a Cable Trap
(80) to the bracket on the Leg Press Upright (4) with a
3/8Ó x 2Ó Bolt (50) and a 3/8Ó Nylon Locknut (42).
The
Cable Trap must be oriented as shown and be
positioned to hold the Cable in the groove of the
Pulley.
20.
Locate one of the pre-assembled pairs of Pulley
Plates (31) and 3 1/2Ó Pulleys (82).
Route the Butterfly Cable (89) under the indicated
3 1/2Ó Pulley (82). The end of the Pulley Plates (31)
with two holes should be downward. Refer to the inset
drawing.
Make sure the Cable is between the Cable
Trap (80) and the Pulley, and that the Cable Trap is
positioned to hold the Cable in place.
Tighten the 3/8Ó x 2Ó Bolt (50) and the 3/8Ó Nylon
Locknut (42, not shown).
21. Wrap the Butterfly Cable (89) around a 3 1/2Ó Pulley
(82) as shown. Attach the Pulley and a Cable Trap
(80) to the other side of the bracket on the Leg Press
Upright (4) with a 3/8Ó x 2Ó Bolt (50) and a 3/8Ó Nylon
Locknut (42).
The Cable Trap must be oriented as
shown and be positioned to hold the Cable in the
groove of the Pulley.
22.
Note: The Left Arm (6) is shown removed for easi-
er part identification.
Insert a 5/16Ó x 1Ó Bolt (95)
through the bracket on the Left Arm. Fully tighten a
5/16Ó Nylon Jam Nut (91) onto the Bolt.
Slide the free end of the Butterfly Cable (89) onto the
5/16Ó x 1Ó Bolt (95). Thread another 5/16Ó Nylon Jam
Nut (91) onto the Bolt,
but do not fully tighten it.
Leave enough room between the two Jam Nuts for
the Cable to pivot.
12
22
19
20
21
6
End with
two holes
should be
down
82
31
4
89
82
50
80
4
42
89
82
50
80
89
89
50
80
95
91
89
42
