12
TIGHTENING THE CABLES
Woven cable, the type of cable used on the weight
rack, can stretch slightly when it is first used. If the
cables need to be tightened, remove the M10 Nylon
Locknut (20) and the M10 x 45mm Bolt (18) from the
lower ends of the Pulley Plates (27). Reattach the
3 1/2” Pulley (16) and Cable Trap (26) to the next
higher set of holes in the Pulley Plates. Make sure
the Cable Trap holds the Low Cable (24) in the
groove of the Pulley. Continue to move the Pulley up
until the Cable is tight.
Do not overtighten the
Nylon Locknut. The Pulley must be able to turn
freely.
ATTACHING WEIGHTS TO THE WEIGHT CARRIAGE
To use the Weight Carriage (7), slide the desired
amount of weight (not included) onto each side of the
weight tube on the Weight Carriage.
To use Olympic weights, press two Weight Adapter
Bushings (36) into the ends of each Weight Adapter
(35). Slide a Weight Adapter onto each side of the
weight tube on the Weight Carriage (7). Insert the two
Lock Pins (34) into the weight tube.
36
36
35
35
34
34
7
Weight Tube
WARNING:
Do not place more than
150 pounds on the Weight Carriage (7). Always
place the same amount of weight on each side
of the Weight Carriage.
26
16
24
20
27
18
Summary of Contents for Pro 525
Page 17: ...17 NOTES...