17
41. Route the Weight Cable (110) over a 90mm
Pulley (63) and down through the Right Top
Frame (5). Attach the Pulley inside the Top Frame
with an M10 x 80mm Bolt (75), two M10 Washers
(99), two M10 x 19mm Spacers (102), and an
M10 Nylon Locknut (90).
43. Wrap the Weight Cable (110) over a 90mm Pulley
(63). Attach the Pulley to the indicated bracket on
the Right Top Frame (5) with an M10 x 43mm
Bolt (80) and an M10 Nylon Locknut (90).
44. Wrap the Weight Cable (110) over a 90mm Pulley
(63). Attach the Pulley and a Cable Trap (68) to
the indicated bracket on the Right Top Frame (5)
with an M10 x 43mm Bolt (80) and an M10 Nylon
Locknut (90).
Make sure the Cable Trap is ori-
ented to hold the Cable in the groove of the
Pulley.
45. Set the M12 Washer (33) on top of the Weight
Tube (47). Thread the M12 Nut (49) all the way
onto the Weight Cable (110).
Thread the Weight Cable (110) into the Weight
Tube (47) a couple of turns.
42. Wrap the Weight Cable (110) under a 90mm
Pulley (63). Attach the Pulley, a Cable Trap (68),
and two Half Finger Guards (66) at the second
hole from the top of the two Pulley Plates (51)
with an M10 x 48mm Bolt (64) and an M10 Nylon
Locknut (90).
Make sure the Cable Trap and
Finger Guards are oriented as shown.
41
42
43
5
Bracket
44
45
5
63
90
99
99
75
102
110
63
90
64
110
66
66
68
51
51
90
63
80
110
5
Bracket
Attach pulley
on this side
80
63
68
90
110
47
33
49
110
