6.
Slide the Left Upright (42) onto the indicated M8 x
48mm Carriage Bolts (3). Hand-tighten an M8
Nylon Locknut (7) onto each Carriage Bolt. Be sure
that the Upright is turned as shown.
Do not tighten
the Nylon Locknuts yet.
Attach the Right Upright (43) in the same manner.
Attach the Left Barbell Lock Pin (46) to the Left
Upright (42) with an M8 Nylon Locknut (7). Attach
the Right Barbell Lock Pin (17) to the Right Upright
(43) in the same manner.
The Barbell Lock Pins
must be oriented as shown.
7.
Attach the Cross Brace (30) to the Lower Lat Tower
(23) with two M8 x 50mm Bolts (1), two M8
Washers (2), and two M8 Nylon Locknuts (7).
Attach the Cross Brace (30) to the Left Upright (42)
with two M8 x 68mm Bolts (8), two M8 Washers (2),
and two M8 Nylon Locknuts (7).
Attach the Cross Brace (30) to the Right Upright
(43) with two M8 x 68mm Bolts (8), two M8
Washers (2), and two M8 Nylon Locknuts (7).
Tighten all M8 Nylon Locknuts (7) used in steps
1, 6, and 7.
8.
Press a 1 1/2” Round Inner Cap (14) into each end
of the Adjustment Tube (37).
Set the Adjustment Tube (37) into one set of adjust-
ment brackets on the Left and Right Uprights (42,
43).
8
6
7
8
42
43
3
7
7
7
7
2
2
2
42
23
43
1
8
8
30
42
43
Adjustment
Brackets
14
14
37
46
17
7
7
