10
18
15
Metal
Cover
Groove
2
17
99
17. Pull the Crossbar Cable (99), which is attached
inside of the Mech Frame (not shown), up
between the Upright (2) and the Pulley Plate (68).
Attach another “V”-pulley (14) to the Upright (2)
and Pulley Plate (68) with an M10 x 58mm Button
Bolt (131) and an M10 Nylon Locknut (103).
Make
sure that the Crossbar Cable (99) is between
the two “V”-pulleys.
Tighten the M10 Nylon Locknuts (103) used in
steps 16 and 17.
15. Insert the connector on the Console (67) into the
socket on the Upper Wire Harness (71).
The con-
nector should slide easily into the socket and
snap into place. If the connector does not slide
easily and snap into place, turn the connector over
and then insert it.
Make sure that the connector and wires appear as
shown in the inset drawing.
IF THE CONNECTOR
IS NOT INSERTED PROPERLY, THE CONSOLE
MAY BE DAMAGED WHEN THE POWER IS
TURNED ON.
Push the excess wire into the Upright (2).
Attach the Console (67) to the Upright (2) with
four M4 x 70mm Screws (114).
16. Attach a “V”-pulley (14) and the Pulley Plate (68)
to the Upright (2) with an M10 x 58mm Button
Bolt (131) and an M10 Nylon Locknut (103).
Do
not tighten the Locknut yet.
15
16
17
114
71
67
2
114
14
68
103
131
2
103
131
99
14
68
2
18
18
16
132
132
18. Attach a Small Guide Spacer (18), a Large Guide
Spacer (17) and two Crossbar Guides (15) to the
Upright (2) with an M10 x 152mm Bolt (132).
Pull the Crossbar Cable (99) up between the
Crossbar Guides (15). Press the metal cover on
the Cable into the groove in the Crossbar Block
(16). Attach a Small Guide Spacer (18), the
Crossbar Block, and the two Crossbar Guides
(15) to the Upright (2) with another M10 x 152mm
Bolt (132).
Make sure the ends of the Cable do
not wrap around each other below the “V”-
pulleys (14) used in steps 16 and 17 (refer to
the CABLE DIAGRAM on page 20).