12
22.
Locate the Short Cable (58).
Route the
Short Cable under the 3 1/2” Low Pulley (77).
Be sure that the end of the Cable with the
ball is on the indicated side of the Pulley
and that the Cable is between the Pulley
and the welded spacer on the Leg Lever
(29).
Tighten the 3/8” x 3 1/2” Bolt (16) and
the 3/8” Nylon Locknut (not shown).
23. Wrap the Short Cable (58) around a “V”-
Pulley (6). Attach the Pulley and a Long
Cable Trap (50) inside the bracket on the
Seat Frame (36) with a 3/8” x 2 1/2” Bolt (7)
and a 3/8” Nylon Locknut (21).
Be sure that
the Cable Trap is turned to hold the Cable
in place and that the Cable is routed
around the Pulley as shown.
24. Wrap the Short Cable (58) around a 3 1/2”
Pulley (15). Attach the Pulley to the Rocker
Arm (32) with a 3/8” x 3 1/2” Bolt (16), a 3/8”
Flat Washer (9), and a 3/8” Nylon Locknut
(21).
Be sure that the Cable Trap (66) is
turned to hold the Cable in place and that
the Cable is routed around the Pulley as
shown.
25.
Note: The 3 1/2” Pulley (15) labelled in this
step is pre-attached. It is shown removed
for easy part identification.
Route the Short Cable (58) around the 3 1/2”
Pulley (15) attached to the lower hole in the
Front Upright (42).
Be sure that the Cable
Trap (66) is turned to hold the Cable in
place and that the Cable is routed around
the Pulley as shown.
Tighten the 3/8” Nylon
Locknut (21) and the 3/8” x 3 3/4” Bolt (71).
25
22
23
24
CA
BL
E
AS
SE
M
BL
Y
58
77
Ball
16
58
6
21
16
66
15
32
9
21
29
7
50
36
58
42
21
71
58
9
66
15
Welded Spacer
