6
ASSEMBLY
1. Orient the Front Stabilizer (29) so that the warn-
ing decals are facing upward.
Attach the Front Stabilizer (29) to the Front Leg
(2) with two M10 x 63mm Carriage Bolts (18)
and two M10 Locknuts (19).
Do not tighten the
Locknuts yet.
2. Attach the Front Leg (2) to the Frame (1) with
two M10 x 63mm Bolts (16), two M10 Large
Washers (27), and two M10 Locknuts (19).
Do
not tighten the Locknuts yet.
1
2
19
19
Warning
Decals
18
2
1
19
19
16
27
27
2
29
• Assembly requires two persons.
• Because of its size and weight, assemble the
weight bench in the location where it will be used.
Make sure that there is enough clearance to walk
around the weight bench as you assemble it.
• Place all parts in a cleared area and remove the
packing materials. Do not dispose of the packing
materials until you complete all assembly steps.
• To identify small parts, see page 5.
• The following tools (not included) may be required
for assembly:
two adjustable wrenches
one rubber mallet
one standard screwdriver
one Phillips screwdriver
Assembly will be easier if you have your own set
of wrenches. To avoid damaging parts, do not use
power tools.
