WEGOMA Porta Master PM3000, Operating Manual

Page: 36 / 118

36
Porta Master PM3000
Glue recommendation: WEGOMA skg 170
Kleiberit: EVA-SK788, Dorus: KS217, Jowat: 280.40
• The chipboard should not have a too raw cutting area!
• Panels and material of the edges need to have room temperature!
• Good humidity of the wood is 8-10%. Other data might affect the adhesion!
• Room temperature should not be below 18°C – Avoid draught!
• Always work with sufficient contact pressure on the edge – not sufficient pressure causes errors
during adhesion!
• Always check sufficient moistening of the edge with sample edge!
• Store the hot melt adhesive in a cool and dry place and keep it closed!
• Hot melt adhesives will release vapours also when they are used according to the prescribed
processing temperature. Hence provisions for elimination of the vapours have to be implemented, e.g.
appropriate suction!
• The glue lid and the glue adjustment screw shall not be opened or turned when cold. These parts will
stick to the surface after the glue has cooled down and will only loosen when device is heated again
(refer to operating manual).
• Rests of glue have to be removed from the machine after each operating circle or before each use
(cleaning spray WEGOCLEAN or similar).
• Keep dust and shavings away from the machine. Store the machine in the system box which is part of
the delivery. Dirty machines can cause errors during adhesion.
• A filled glue container is sufficient (depending on type of glue) for gluing around 13 m (height of edge:
45 mm) or 25 m (height of edge: 25 mm).
• Always make sure that there is sufficient hotmelt adhesive in the reservoir and that it is totally melted
– otherwise this causes errors during adhesion!
• Operate the feed for around 7 minutes when you refill the granulate.
• Inlay edges up to a maximum of 2.0 mm can be processed. For gluing the edges on the side with the
glue must be laminated and ground. (Observe manufacturer’s instructions)
• The carrier material for processing the edges has to be exactly rectangular and dust-free!
• It is absolutely necessary to do a test gluing when gluing inner and outer radii.
You can also use other adhesives. In any case the adhesive bond has to be checked. We cannot be hold
liable.