4 iPump
Quick Start Guide
800009-02 Rev.B
4
44
4
Next, start your iPump
Next, start your iPump
Next, start your iPump
Next, start your iPump
as follows:
a)
Connect the ac power cord to the iPump's IEC receptacle
(
ffff
, Figure 1) and to a 100-to-120 Vac or 200-to-240 Vac
source.
b)
Set the power switch to the On position (
I
) and press and
hold the Enter button (
ENTER
) on the front panel for two
seconds. The iPump will power up and begin the boot
process. Outputs are muted during the short initialization
time. All eight LED indicators flash on and off as the unit
begins initialization. Until you configure your iPump's RF
settings (see Step
6
66
6
), a loss-of-carrier alarm may be
displayed (red
ALARM
LED indicator is lit and LCD screen
indicates the alarm state). RF settings are not necessary for
units with the optional ASI input.
NOTE
: To easily restart the iPump any time after a
normal shutdown (see Step
9
99
9
), simply press the Enter
button (
ENTER
) on the iPump’s front panel (refer to the
User's Reference Manual for details). If the receiver is
tracking a carrier signal, the green
CARRIER
LED will
light.
