WEG CFW500 Series, Safety Manual

Page: 18 / 81

CFW500 | 17
E
ng
lis
h
Commissioning
3 COMMISSIONING
3.1 PARAMETERS RELATED TO THE SAFETY FUNCTIONS MODULE
The parameters of the CFW500 frequency inverter that are directly related to the safety functions
module are presented below.
Symbols used to describe parameter properties:
„
ro: read only parameter.
„
sy: parameter only visible on HMI when the safety functions module is in the programming mode.
3.1.1 Parameters
P0028 - Safety Functions Module
Adjustable
Range:
0 = STO Jumper Connector
1 = CFW500-SFY2 Factory
Setting:
-
Properties: ro
Access Groups
via HMI:
READ
Description:
It identifies the safety functions module connected to the frequency inverter, according to
Table 3.1 na página 17 .
Table 3.1: Identification of the safety functions module
Name Description P0028
STO Jumper Connector Frequency inverter without functional safety 0
CFW500-SFY2
Frequency inverter is equipped with a safety functions module
capable of performing STO and SS1-t
1
NOTE!
Either the STO jumper connector or the CFW500-SFY2 must be installed on
top of the frequency inverter. Otherwise, the fault message "F0086" will be
displayed by the frequency inverter during power-on.
P0106 - 3
rd
Ramp Time
Adjustable
Range:
0.1 to 999.0 s
Factory
Setting:
5.0 s
Properties:
Access Groups
via HMI:
Description:
It defines the acceleration time from zero to maximum speed (P0134) or deceleration from
maximum speed (P0134) to zero for the 3
rd
Ramp.