WEG CFW300 V1.3X, Programming Manual

Page: 98 / 157

Digital and Analog Inputs and Outputs
12-6 | CFW300
12
12.3 ANALOG OUTPUT
The analog output (AOx) is configured by means of three types of parameters: Function, Gain and Signal, according
to the block diagram below.
The quantity of analog outputs depends on the expansion accessory IO's. For further details, refer to the installation,
configuration and operation guide of the IO's expansion accessory used.
Function
AO1 - P251
AO2 - P254
Gain
AO1 - P252
AO2 - P255
AO1 - P014
AO2 - P015
Value
AO1
(*)
AO2
(*)
Signal
AO1 - P253
AO2 - P256
(*) Control terminals available on the accessory.
Figure 12.3: Block diagram of the analog output (AOx)
P014 - Value of Analog Output AO1
P015 - Value of Analog Output AO2
Adjustable
Range:
0.0 to 100.0% Factory
Setting:
Properties: ro
Description:
These read-only parameters indicates the value of analog outputs AO1 and AO2 in percentage of the full scale.
The indicated values is obtained after multiplication by the gain. Check the description of the parameters P251
to P256.