Remote Serial HMI
E
ng
lis
h
1 SAFETY INFORMATION
1.1 SAFETY WARNINGS
NOTE!
Only use the remote serial HMI
(CFW100-KHMIR) on WEG CFW100
series inverters.
It is recommended reading the CFW100
user’s manual, as well as the installation,
configuration and operation guide of
the RS485 (CFW100-CRS485) before
installing or operating this accessory.
The content of this guide provides
i m p o r t a nt i nfo r m ati o n fo r th e f u l l
understanding and proper operation of
the remote serial HMI.
NOTE!
In order to check the firmware version of
this accessory, press and hold the “P” key
for over three seconds.
1.2 PRELIMINARY RECOMMENDATIONS
ATTENTION!
Always disconnect the general power
supply before connecting or disconnecting
the accessories of the CFW100 frequency
inverter.
Wait for at least ten minutes for the full
discharge of the inverter.
2 GENERAL INFORMATION
This guide provides directions for the installation,
configuration and operation of the Remote serial HMI
(CFW100-KHMIR).
Buy: www.ValinOnline.com | Phone 844-385-3099 | Email: [email protected]
