9
connecting mode by default, at that time, the Wi-Fi indicator on the power base will
blink rapidly (3 times/second).
6.3.2 Follow steps 6 – 12 to add device in the app per Figs. (6) – (12)
Step 6: Click “Add Device” or the "+" button at the upper right corner.
Step 7: Firstly, select “Kitchen Appliances” and then select “Smart Kettle”.
Step 8: Check that the Wi-Fi indicator on the kettle base is rapidly blinking. If not,
press and hold the Wi-Fi reset button (same as the On/Off button). Once completed,
click “Confirm indicator rapidly blink” on the app, and then click “Next”.
Step 9: The “Wi-Fi Name” is the name of the Wi-Fi connected to the mobile phone
by default, then enter the Wi-Fi password and click “Next”.
Step 10: The “Adding device” interface is shown.
NOTE:
If the app shows it has failed to connect, it is very likely that your Wi-Fi is
not in the 2.4GHz band only. If this issue persists, please try the “slow connecting
mode” in section 6.4 below and it should still let you connect your kettle to the
Wi-Fi. All Wi-Fi routers have a 2.4 GHz band, but some also have a 5GHz band and
the 5GHz needs to be disabled. Please check with your Wi-Fi provider on how to
check and change that and all the relevant information should be on their websites.
Step 11: The kettle is added successfully and it is by default named “kettle”.
Step 12: Click “Done” and the kettle control interface is shown.
NOTE:
The Wi-Fi indicator will keep blinking if the Wi-Fi has not been connected
well. If no action is taken to connect the Wi-Fi within 10 minutes, the connection
mode will switch off (Wi-Fi indication off). To reset Wi-Fi connection mode, press
and hold 100
℃
preset button for over 3 seconds until Wi-Fi indicator starts blinking
again. The Wi-Fi indicator will light solidly when the Wi-Fi has been connected
well. If the Wi-Fi is disconnected, the Wi-Fi indicator will keep blinking. The Wi-Fi
indicator will make switch between the conditions of “Rapidly blink” and “Slowly
blink” after holding and pressing the On/Off button for more than 3 seconds when
the kettle has not been connected to Wi-Fi. When the kettle is connected to Wi-Fi,
hold and press the button of the On/Off button for more than 3 seconds, the Wi-Fi
data will be cleared and the kettle will enter into the Wi-Fi connecting mode again.
Summary of Contents for KE4071TB-GS
Page 12: ...10 6 7 8 9 10 11 ...
Page 15: ...13 16 17 18 19 20 21 22 23 6 5 Temperature measurement conversion ...
Page 23: ...21 40 41 42 43 44 ...
Page 30: ......