4
5
6
General Maintenance
There are two O-rings in the tail cap. Use silicone to keep the O-rings well
lubricated. It is important to lubricate the O-rings if the video light has not
been used in a long time or if the O-ring is hard. If the O-ring is damaged,
broken or deformed it should be replaced with a new O-ring. One spare
O-ring is included when you purchase your torch.
NOTE: Do not use a sharp tool to remove the O-ring.
Warnings
★ Do not open the tail cap when the torch is in the water；
★ Do not shine the light directly into your eyes or another person's eyes；
★ Do not touch the battery or the charger with wet hands；
★ Only use the manufacturer's battery and charger with this system；
★ If the torch will not be used for a long period of time the battery should
be removed. Failure to comply with these warnings may result in damage
to the video light and will nullify the warranty.
To Switch Modes
When the light is on: Press the right and left buttons at the same time, Then
immediately release the right and left buttons. Open the SOS/Flash Light.
If you want to exit this mode, just operate again.
Wide Light → SOS/Flash Light
Adjust brightness
When the light is on: Press the right button, Then immediately release the
right button, Adjust brightness.
Wide Light：100% → 75% → 50% → 25%
To Charge the Batter y
1. Insert the DC charger plug into the battery(as shown in the diagram below).
2. Plug the charger into the wall outlet.
When the battery starts to charge the indicator light on the charger will
be red.
When the battery is fully charged the indicator light on the charger will
turn green.
Thermal protection
When the inner temperature of the torch becomes too high the video light
will automatically decrease the brightness of the light prevent the light
from over heating.
Batter y Stretch
When the battery level is low the troch will automatically decrease the
brightness to conserve power. When the battery is empty the torch will
power-off.
Remote control
The remote control is an optional accessory.
