Weco WF-103, Instruction Manual, Page: 4 / 32

Cod.006.0001.1040
10/07/2017 v2.12
ENGLISH
WF-103
4/32
1 INTRODUCTION
IMPORTANT!
This handbook must be consigned to the user prior to
installation and commissioning of the unit.
Read the "General prescriptions for use" handbook supplied
separately from this handbook before installing and
commissioning the unit.
The meaning of the symbols in this manual and the associated
precautionary information are given in the "General
prescriptions for use”.
If the "General prescriptions for use" are not present, it is
mandatory to request a replacement copy from the
manufacturer or from your dealer.
Retain these documents for future consultation.
KEY
This symbol identifies an action that occurs automatically as
a result of a previous action.
This symbol identifies additional information or a reference to
a different section of the manual containing the associated
information.
§ This symbol identifies a reference to a chapter of the manual.
This symbol accompanies important information concerning
the execution of the relevant operations.
Wire feeder WF-103 is designed for connection to a power source for
MIG/MAG welding.
The welding modes and procedures available are those indicated in
the table.
MODE PROCEDURE
MMA
ARC AIR
MIG/MAG
TWO STEP (2T)
FOUR STEP (4T)
THREE LEVEL (3T)
2 FRONT PANEL
1 2 3 4 5 6
1: EURO TORCH welding socket.
2: Connector for coolant hose.
Power source  Torch
3: Connector for coolant hose.
Torch  Power source
4: Pre-arrangement for flowmeter to adjust the gas (l/min) at the
torch outlet (purchasing and installing the relative kit).
5: Remote controller connector.
6: MMA clamp welding socket.