4
ENGLISH
Need help?
www.weboost.com
Customer Support 866-294-1660
Mon.- Fri. Hours: 7 am to 6 pm MST
• With the bracket in place, attach the
magnet base of the antenna to the flat
surface of the bracket. The antenna
must be mounted vertically for the best
signal.
2. Install the Mounting Bracket and Drive
4G-S.
Put your Drive 4G-S in the Mounting
Bracket (see instructions under Vehicle
Installation) and place it in a convenient
location such as a desk or table top in the
room where you will use the phone. The
location should be at least three feet from
the Outside Antenna to avoid oscillation
(feedback). Your cell phone must be in the
cradle for the Drive 4G-S to amplify the
signal. Use a Bluetooth headset, wired
hands-free device or speakerphone for
talking on the phone.
3. Attach the antenna to the Drive 4G-S.
Connect the cable from the Outside
Antenna to the antenna connector on the
bottom of the Drive 4G-S. Do NOT plug
in the power supply (next step) until the
Outside Antenna cable is connected to the
Drive 4G-S.
4. Power up your Drive 4G-S. Connect the
power cable to the mini-USB port on the
bottom of the Drive 4G-S. Then insert the
adapter and power it on. Use only the
supplied weBoost power supply.
6. Power up your Drive 4G-S. Connect the
power cable to the mini-USB port on the
bottom of the Drive 4G-S. Then insert the
adapter into the vehicle 12V DC power
source. Use only the supplied weBoost
power supply. While the Drive 4G-S may
remain on, leaving the Drive 4G-S on
in a vehicle when it is not running may
discharge the battery in a day or two. Also
note that some 12V DC power sources
are shut down when the vehicle ignition
is turned to off. Use a Bluetooth headset,
wired hands-free device or speakerphone
for talking on the phone.
Option 2: In-Building Installation
Note: Home Office Accessory Kit sold
separately
1. Install the Outside Antenna to a window.
For best results:
• Select a window on the side of the
building where you get the strongest
cell signal.
• Attach the suction cup bracket (sold
separately) to the inside of a window so
the cable will reach the location of the
Mounting Bracket and Drive 4G-S. Place
the bracket as high on the window as
possible.
NOTE: Many newer energy efficient dual
pane windows use a metal coating that may
decrease the strength of a cellular signal,
reducing the effectiveness of the Drive 4G-S.
If you have dual pane windows, consider a
weBoost signal boost product that provides
an option for mounting an antenna on an
outside wall or roof of a building.
