Need help?
https://cellphonesignalbooster.us
Customer Support
Mon.- Fri. Hours: 7 am to 6 pm MST
800-501-3153
12
ENGLISH
Safety Guidelines
WARNING:
To uphold compliance with network protection standards, all active cellular devices must maintain
at least 6 feet of separation distance from Panel and Dome antennas and 4 feet of separation
distance from Desktop antennas.
WARNING:
Connecting the Signal Booster directly to the cell phone with use of an adapter will damage the
cell phone.
WARNING:
Use only the power supply provided in this package. Use of a non-weBoost product may damage
your equipment.
WARNING:
The Signal Booster unit is designed for use in an indoor, temperature-controlled environment
(less than 150 degrees Fahrenheit). It is not intended for use in attics or similar locations subject
to temperatures in excess of that range.
WARNING:
Take care to ensure that neither you nor the pole comes near any power lines during installation.
RF SAFETY WARNING:
Any antenna used with this device must be located at least 8 inches from all persons.
Lightning
Surge Protector
(sold separately)
To Outside
Antenna
To Signal Booster
Ground Wire
(not included)
!
RECOMMENDED: INSTALLING THE LIGHTNING SURGE PROTECTOR
(SOLD SEPARATELY)
INSTALL THE LIGHTNING SURGE PROTECTOR (LSP) CLOSE TO THE SIGNAL
BOOSTER. ATTACH THE CABLE FROM THE OUTSIDE ANTENNA TO THE
SURGE PROTECTOR.
ENSURE THE LSP IS PROPERLY GROUNDED
.
#859992-75 OHM MAY BE PURCHASED AT
HTTPS://CELLPHONESIGNAL
BOOSTER.US OR BY CALLING 800-501-3153.
BEFORE USE
, you
MUST REGISTER THIS DEVICE
with your wireless provider
and have your provider’s consent. Most wireless providers consent to the use of
signal boosters. Some providers may not consent to the use of this device on their
network. If you are unsure, contact your provider.
You
MUST
operate this device with approved antennas and cables as specified by
the manufacturer. Antennas
MUST
be installed at least 20 cm (8 inches) from any
person.
You
MUST
cease operating this device immediately if requested by the FCC or a
licensed wireless service provider.
WARNING.
E911 location information may not be provided or may be inaccurate
for calls served by using this device.
This is a CONSUMER device.
This device complies with Part 15 of FCC rules. Operation is subject to two conditions: (1) This device may not cause
harmful interference, and (2) this device must accept any interference received, including interference that may cause
undesired operation. Changes or modifications not expressly approved by weBoost could void the authority to operate this
equipment.
Each Signal Booster is individually tested and factory set to ensure FCC compliance. The Signal Booster cannot be
adjusted without factory reprogramming or disabling the hardware. The Signal Booster will amplify, but not alter incoming
and outgoing signals in order to increase coverage of authorized frequency bands only. If the Signal Booster is not in use
for five minutes, it will reduce gain until a signal is detected. If a detected signal is too high in a frequency band, or if the
Signal Booster detects an oscillation, the Signal Booster will automatically turn the power off on that band. For a detected
oscillation the Signal Booster will automatically resume normal operation after a minimum of 1 minute. After 5 (five) such
automatic restarts, any problematic bands are permanently shut off until the Signal Booster has been manually restarted
by momentarily removing power from the Signal Booster. Noise power, gain, and linearity are maintained by the Signal
Booster’s microprocessor.
