![weBoost 460059 Installation Manual Download Page 18](http://html1.mh-extra.com/html/weboost/460059/460059_installation-manual_949320018.webp)
16
ENGLISH
460059
PWO460059
5 dB (nominal)
> 110 dB
5 VDC
12 .7
12 .2
12 .8
12 .6
12 .8
4726A-460059
F-Female
75 Ohms
698-716 MHz, 729-746 MHz, 746-757 MHz, 776-787 MHz, 824-849 MHz, 869-894 MHz, 1710-1755 MHz,
1850-1915 MHz, 1930-1995 MHz, 2110-2155 MHz
700 MHz B12/17
24 .8
700 MHz B13
25 .0
800 MHz B5
25 .3
1700 MHz B4
25 .2
1900 MHz B2
25 .1
Model
FCC
IC
Connectors
Antenna Impedence
Frequency
Noise Figure
Isolation
Power Requirements
Power output for single cell
phone (Uplink) dBm
Power output for single cell
phone (Downlink) dBm
Specifications
Destination RV Booster
Each Signal Booster is individually tested and factory set to ensure FCC compliance. The Signal Booster cannot be adjusted without factory reprogramming or disabling the hardware. The
Signal Booster will amplify, but not alter incoming and outgoing signals in order to increase coverage of authorized frequency bands only. If the Signal Booster is not in use for five minutes,
it will reduce gain until a signal is detected. If a detected signal is too high in a frequency band, or if the Signal Booster detects an oscillation, the Signal Booster will automatically turn the
power off on that band. For a detected oscillation the Signal Booster will automatically resume normal operation after a minimum of 1 minute. After 5 (five) such automatic restarts, any
problematic bands are permanently shut off until the Signal Booster has been manually restarted by momentarily removing power from the Signal Booster. Noise power, gain, and linearity
are maintained by the Signal Booster’s microprocessor.
The term “IC” before the radio certification number only signifies that Industry Canada technical specifications were met. This device complies with Part 15 of FCC rules. This device contains
licence-exempt transmitter(s)/receiver(s) that comply with Innovation, Science and Economic Development Canada’s licence-exempt RSS(s). Operation is subject to two conditions: (1) This
device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Changes or modifications
not expressly approved by weBoost could void the authority to operate this equipment.