manual Webheat Control P30 EN.docx
www.webheat.eu
Connection:
This controller may only be installed and
connected by a national certified electrician.
The sensor should be connected to
terminal 1 and 2.
Heater cable should be connected to
terminal 11, 12 and 15. In case the load
is smaller than 1500 Watt, you can use
either terminal 11 OR 12. When load is
higher than 1500 Watt use BOTH
terminals 11 and 12.
Extra bridge cable should be connected
between terminal 14 and 16.
The earth of the heating cable and the
earth of the power supply should be
connected beside the thermostat to
the ground terminal.
