9
(4)
(5)
(1)
(2)
(3)
INSTALL WIRE LID HOLDER ASSEMBLY
You will need: Wire lid holder assembly and a 1/2 inch open-end or an adjustable wrench.
Remove 5/16-18 hex nut
(1)
, 5/16 inch lock washer
(2)
and 7/8 inch aluminum washer
(3)
from each
end of wire lid holder. Finger tighten remaining 5/16-18 hex nut
(4)
.
Note - Bushings
(5)
should roll freely on wire lid holder.
Insert ends of wire lid holder through frame assembly and bowl on outside of wheel legs. Place 7/8
inch aluminum washer
(3)
, 5/16 inch lock washer
(2)
then 5/16-18 hex nut
(1)
on each end of the
wire lid holder and tighten.
INSTALL TUCK-AWAY FRAME SUPPORT
Swing Tuck-Away frame support up and set wire lid holder, with tabs centered
(1)
, into slots in frame
support.
8
9
(1)
ASSEMBLY
