Weber GENESIS GOLD C, Owner'S Manual

Page: 23 / 32

C-3
Gas Instructions
Check for gas leaks
DANGER
Do not use an open flame to check for gas
leaks. Be sure there are no sparks or open
flames in the area while you check for leaks.
Sparks or open flames will result in a fire or
explosion, which can cause serious bodily
injury or death and damage to property.
WARNING: You should check for gas leaks every
time you disconnect and reconnect a gas fitting.
Note - All factory-made connections have been thoroughly
checked for gas leaks. The burners have been flame-tested.
As a safety precaution however, you should recheck all
fittings for leaks before using your Weber Gas Barbecue.
Shipping and handling may loosen or damage a gas fitting.
WARNING: Perform these leak checks even if your
barbecue was dealer or store assembled.
You will need: a soap and water solution, and a rag or
brush to apply it.
Note - Since some leak test solutions, including soap and
water, may be slightly corrosive, all connections should be
rinsed with water after checking for leaks.
Make sure side burner is OFF.
To perform leak checks: open cylinder valve by turning the
cylinder valve hand-wheel counterclockwise.
WARNING: Do not ignite burners when leak
checking.
Check for leaks by wetting the connections with the soap
and water solution and watching for bubbles. If bubbles
form or if a bubble grows, there is a leak.
Remove control panel and burner control knobs
You will need: Phillips screwdriver.
1) Remove control knobs.
2)
Unhook side burner from Cookbox Frame.
3)
Remove screws with a Phillips screwdriver
4) Pull up igniter button until it sticks in the up position and
remove control panel from grill.
(3)
(4)
(1)
(2)
5) Replace control panel when Leak Check is completed.