Weber 7360001, Installation Manual

Page: 100 / 178

32
7
2
3
1
5
6
4
MAINTENANCE
REPLACING MAIN BURNERS
Note: Your Summit ® gas grill must be off and cool.
A) Turn gas off at source .
B) Disconnect gas supply .
C) Remove cooking grates .
D) Remove Flavorizer
® bars .
E) Remove smoker box (if included with your model) .
Remove Control Panel
Tools needed: Screwdriver, pliers, and towels .
A) Remove burner control knobs (1) .
B) Open both doors . With a screwdriver, remove screws from the underside of control
panel
(2) .
C) Lift and remove battery housing located inside grill cabinet (3) .
D) Using needle-nose pliers, disconnect wire terminals from the top of battery housing
(4) . Do not pull on the wires; remove them by pulling on the wire terminals.
E) Place towels on the tops of both door assemblies .
This will protect control panel and door assemblies from getting scratched on
next step.
F) Tilt bottom of control panel forward . Lift slightly
(5) and then rotate it face down to
rest on tops of door assemblies . (Be careful not to break or disconnect wires for the
control panel LEDs .)
G) Carefully pull battery wires out from the inside of the grill cabinet
(6) .
H) Fully open right door . Place control panel on floor, leaning against towel covering
right door assembly
(7) .
Remove Burner Tubes
Tools needed: 3/8" nut drivers .
A) Using a 3/8" nut driver, remove the screws that secure manifold assembly to the
cookbox . Pull manifold assembly away from burner tubes and let it hang loose
from grill cabinet
(8) . Do not disconnect the blue wire from the left side of the
manifold assembly.
B) Pull the selected burner tube(s) through the front of cookbox and replace with new
burner tube(s) (9) .
The grills illustrated in this Owner’s Guide
may vary slightly from the model purchased .
6
7
8
9