Possible applications | 27
5.3
Pulling
After the chain set (as explained in chapter 4.6) has been mounted on the spreader tips, the
spreader device can be used for pulling.
For this, the chains must be tightly tensioned and must be tensed only in the pulling direction.
To tension the chain, only one lock can be pressed in, so that the chain can be pulled through
the holder.
If the range of movement is not sufficient, tension chains or other means must be used so that
the spreader can be reopened and the chain retensioned.
ATTENTION!
Store the pulling chains with locks mounted about 10–20 cm from the end.
Check the chains prior to every use. Check that the weight does not stress
the tip of the hook, but lies in the middle of the hook instead.
»
Do not make any repairs on your own.
»
Do not stress the chains beyond the permitted load carrying
capacity.
»
Do not load with a jerking movement.
»
Do not galvanize or paint the chains.
»
Do not shorten the chain by knotting it.
»
Do not subject the chains to heat stress.
»
Use the chains and accessories only between –40°C and +200°C.
»
During all maintenance work, observe the applicable German
accident prevention regulations (UVV) as well as the specifications
of DIN EN 818-7 and DIN 685-5.
»
Chains must only be used for lashing. Lifting loads is not
permitted.
Summary of Contents for SP 35 AS
