Weber mt CR 3-II, Operating And Maintenance Manual

Page: 15 / 28

CR 3-II 15
1
2
3
4
Checking the hydraulic oil level
Check the hydraulic oil level when the machine is at
operating temperature. The guide bar must be in the
transport position – i.e. folded up. The correct oil level
is reached when the oil is in the middle of the view glass.
Mounting the attachment plates
Tighten the screws (1) of the attachment plates (2) with
a torque of 310 Nm.
Installing the protective mat
Fasten the protective mat with holder, screws, spring-lock
washers and nuts on the base plate front and rear.
Ensure that the protective mat rests under the base plate.
Starting
Bring the gas lever into full-throttle position.
Slowly tighten the handle (3) of the reversing starter (4)
until resistance is noticeable.
Allow the handle (3) to slide back into the initial position,
and then forcefully and completely pull it all the way through
with both hands.
Allow the engine to warm up for a few minutes.
If ambient temperatures are below minus 5 degrees
Celsius, comply with the instructions in the operating
manual provided by the engine manufacturer!