20
CR 7-II Hd
1
3
2
Adjust the desired work height of the guide bar with the set
screw (1).
Set the short-circuit switch (2) to “I”.
Open the fuel cock (slide to the right).
Close the choke lever (slide to the left).
Bring the gas lever into the full-throttle position “ON”.
Slowly pull the handle of the reversing starter (3) until
resistance (the compression of the engine) is noticeable.
Allow the handle to glide back into the initial position.
Pull the handle through quickly, forcefully and completely.
Repeat the process if the engine does not start.
Set the gas lever to the idle speed “STOP”.
Allow the engine to warm up for a few minutes.
Open the choke lever (slide to the right).
The machine is ready for operation.
Figure 5
