ASSEMBLY
Remove the machine and contents from the carton. Be sure the carton is empty before discarding.
If you require any assistance with regards to the contents of the lawnmower contact us:
Tel: 01793 333212 - Mon – Fri 8.30am – 5.00pm (excl. Bank Holidays)
Email: [email protected]
MACHINE
FITTING D-HANDLE
1.
Place top handle onto drivesh
aft.
2.
Pos
iti
on lower handle, beneath the top handle in a comfortable opera
ti
ng pos
iti
on
3.
Tighten the four
fi
xing screws.
FITTING THE HARNESS
1.
Place the clasp of the harness, through the Harness Eyelet located on the drivesha
ft
2.
Adjust the Harness to ensure it is comfortable, but
tig
ht enough to allow you to operate the machine
appropriately.
JOINING ATTACHMENT TO THE POWER UNIT
1.
Un
tig
hten the hand-wheel, located on the coupler.
2.
Line up the a
tt
achment sh
aft
with the coupler and insert, pulling the locking pin on the coupler out to
house the a
tt
achment.
3.
When fully housed, secure by
tigh
tening the hand-wheel.
HEDGE TRIMMER
ADJUSTING THE CUTTING HEAD ANGLE (Fig 3)
1.
Stop the engine
2.
Turn the clamp lever an
ti
-clockwise to loosen
3.
Adjust the blade to the required angle, by moving the clamp level up or down the angle adjuster.
4.
Turn the clamp lever clockwise to
tigh
ten.
INSTRUCTION MANUAL
Summary of Contents for WEMC26
Page 2: ......
Page 22: ...PARTS DIAGRAM WEMC26 Engine ...
Page 36: ...Webb Lawnmowers Murdock Road Dorcan Swindon Wiltshire SN3 5HY ...
