Webb WELT26, Operators Manual & Parts Lists

Page: 9 / 28

INSTRUCTION MANUAL
ASSEMBLY
Remove the machine and contents from the carton. Be sure the carton is empty before discarding.
If you require any assistance with regards to the contents of the lawnmower contact us:
Tel: 01793 333212 - Mon – Fri 8.30am – 5.00pm (excl. Bank Holidays)
Email: customerservice@webblawnmowers.co.uk
FITTING GUARD/SHIELD
1. Install the safety cover on the shaft with the safety cover bracket and fixing screws provided.
2. Tighten the screws after setting the safety cover bracket at the appropriate position.
FITTING NYLON LINE CUTTING HEAD
1. Align hole in adapter plate with hole in the shaft and install Allen Key.
2. Thread cutter head onto shaft (turning it anti-clockwise) until it is tight. Remove locking tool.
FITTING D-HANDLE
1. Place top handle onto driveshaft.
2. Position lower handle, beneath the top handle in a comfortable operating position
3. Tighten the four fixing screws.
FITTING THE HARNESS
1. Place the clasp of the harness, through the Harness Eyelet located on the driveshaft
2. Adjust the Harness to ensure it is comfortable, but tight enough to allow you to operate the machine
appropriately.
INSTRUCTION MANUAL
OPERATION
DANGER
All model line trimmers & brushcutters can throw small stones, metal or small objects as well as material
being cut. Do not allow anyone to enter the operating DANGER ZONE with you. The danger zone is an area
15 metres in radius
Insist that persons in the RISK ZONE beyond the danger zone wear eye protection from thrown objects. If
the unit must be used where there are unprotected people, operate at a low throttle speed to reduce the
risk of thrown objects.
DANGER ZONE WITHIN 15 METRES - RISK ZONE GREATER THAN 15 METRES
GENERAL USE
WARNING
Prior to using the machine, ensure all hardware (bolts, screws & nuts) are securely tightened.
Operate the trigger with your right hand & hold the D-Handle with your left hand.
The trigger increases and decreases the power of the engine to the attachment, increasing the
revolution/reciprocation of the attachment.
WORKING PLAN
Limit the amount of time the product is used continuously to a maximum of 40 minutes per session.
Leave the machine to rest between sessions for between 10-20 minutes.
Total amount of work performed per day with the machine, should be limited to 120 minutes maximum.
Continuous use of the machine can cause “Repetitive Stress Injury (RSI)”. If you feel discomfort, redness or
swelling of your hands and fingers or any other body part, consult your doctor.
Check local regulations for sound level and hours of operation constraints.
Never transport the machine, whilst the engine is running.
INSTRUCTION MANUAL
WELT26 193869001 IM.indd 9 07/02/2017 15:43