RS 2500 5
5.1 Manual operation
If necessary, the RS 2500 can be operated manually. It depends on
the situation which procedure for manual operation you must fol-
low.
CAUTION
Inadvertent movements of the manual operation
tool
Risk of injury and/or damage of components.
X
Do not operate the control switch during manual
operation.
X
Reset the control system after operating the
RS 2500 manually. See chapter 5.2.
5.1.1 Manually moving the RS 2500 over a
short range (less than 25 cm)
X
Gain access to the motor assembly.
X
Insert the tool for manual operation in the slot in the motor
(See Fig. 05).
X
Turn the tool to close or open the RS 2500.
Fig. 05: Manual operation tool
5.1.2 Manually moving the RS 2500 over
more than 25 cm
X
Gain access to the motor assembly.
If the RS 2500 is closed and locked, always first un-
lock the RS 2500 by means of the manual operation
tool.
X
Insert the tool for manual operation in the slot in
the motor (See Fig. 05).
X
Turn the tool to open the RS 2500 at least 10 cm
to unlock the system.
X
Remove the tool for manual operation.
X
Disconnect the wiring harness (Fig. 06, 4) from the motor.
X
Remove the 3 bolts (3) and washers (2) from the motor (1).
X
Remove the motor.
Fig. 06:
1
2
3
4
2
2
3
3
Motor removal
X
Push or pull the front beam of the RS 2500 to the desired (open
or closed) position.
Fig. 07: Manual closing or opening
5.2 Reset procedure
3
Make sure there is a minimum of 20 A available.
X
Press and hold the close button.
The RS 2500 closes as far as possible.
X
Release the close button.
X
Press and hold the close button.
After approx. 10 s the RS 2500 slides with small steps until it is
completely closed
The motor produces a loud click sound.
X
Release the close button.
The system has been reset.
Fig. 08: Control system reset
