5
5
Standby
The screen will go to Standby mode after 5
minutes if no entries are made on the screen.
Tap anywhere on the screen to call up the
Home screen.
6
Notification
The notification symbol
appears on the bot-
tom status line to draw your attention to the
current status of the system. Tap on the symbol
to show the corresponding status message.
7
ON/OFF
■
When the screen is switched off:
X
X
Tap the screen.
The screen switches on.
■
When the screen is switched on:
X
X
Tap
.
The colour of the ON/OFF symbol indicates the
operating status (green = switched on, grey =
switched off).
8
Operation
After switching on, the control system starts up
the chiller unit and the connected air handler in
steps and then assumes normal operation. The
control element now shows the current tem-
perature where the cabin temperature sensor
of the chiller unit is installed. Depending on the
installation location, this may also be the tem-
perature of another cabin for example.
After approx. 20 seconds, the base colour of
the control element changes to indicate the op-
erating mode (cooling or heating) in which the
chiller unit was started. Blue indicates cooling
mode, red heating mode. The selection is de-
pendent on the set setpoint temperature and
the room temperature measured by the cabin
temperature sensor.
Note
■
The system only cools under the
following conditions: cabin tem-
perature > 15 °C.Setpoint tem-
perature < cabin temperature.
■
The system only heats under the
following conditions: cabin tem-
perature < 29 °C.
Setpoint temperature > cabin
temperature.
If the cold water temperature is higher (cooling)
or lower (heating) than the cabin temperature,
status message BA11 is displayed and the fan
will not yet be in operation.
In cooling mode, the cold water temperature is
significantly below 15 °C and above 40 °C in
heating mode.
8.1
Setting setpoint temperature
To set the required cabin temperature:
X
X
Tap on the temperature or
on the Home
screen.
The setpoint temperature appears to the right.
X
X
Tap Plus
or Minus
to increase or de-
crease the setpoint temperature.
The Settings menu is automatically exited af-
ter 30 seconds and the value last set is
adopted.
Note
Alternatively:
Save and exit menu immediately:
X
X
Tap Previous
.
8.2
Setting fan speed
X
X
To set the required fan speed tap on Fan
on the Home screen.
With automatic fan control mode selected, the
symbol A appears on the Home screen.
The
control system of the fan automatically adapts
the fan speed.
To manually adapt the fan speed:
X
X
Tap the fan display (design 1, 2) or
.
X
X
You can now change the displayed fan speed
by tapping Plus
or Minus
.
