Weather-Rite XT112, Installation, Operation & Service Manual

Page: 17 / 98

SECTION 6: L
IFTING AN
A
IR
H
ANDLER
11
6.1.3 Liftin g an Upri g ht Air Handler
All air handlers are shipped in the horizontal position.
Prior to lifting an u pright air handler, the follo w ing
steps m u st be performed ( See Page 11, Figure 2 ):
Step 1: The air handler m u st be lifted u sing the t w o
lifting l u gs on the top of the discharge end and the
t w o lifting l u gs on the inlet end, u sing a spreader bar
across the long axis. Lift the air handler off the skid
and place it on a flat, clean, dry s
u rface.
Step 2: Remo v e the lifting l u gs on the inlet end of the
air handler and re-install hard w are.
Step 3: Use all fo u r lifting l u gs on the discharge end
of the air handler to enable the air handler to be lifted
into the
u pright position.
Step 4: Lift the air handler into u pright position.
Step 5: Next, refer to the applicable portions of Page
16, Section 9 for specific mo u nting instr u ctions.
FIGURE 2: Liftin g an Upri g ht Air Handler
Step 1
Remove These
Lifting Lugs
Step 2
Step 3
Step 4
Spreader Bar
I N LET
I N LET
I N LET
I
N
LET