WE-EF KTY234, Installation And Maintenance Instructions Manual

Page: 8 / 20

Installation
The product must be installed and maintained by a
VXLWDEO\TXDOLƂHGSURIHVVLRQDOLQFRPSOLDQFHZLWKODWHVW
building/construction and/or electrical regulations and
relevant legislation.
Warning: Switch off
and isolate the
mains electrical
supply prior to installing and connecting the luminaire.
Notice:
,IWKHOXPLQDLUHLVPRGLƂHGE\DQ\ERG\RWKHU
than the original manufacturer, then the warranty will
no longer be valid and shall become the full respon-
sibility of the modifying person/organisation. Claims
based on defects attributable to improper installation
and/or application, and the consequences thereof, are
excluded.
If the supplied cable of the KTX luminaire is damaged,
it must be replaced by WE-EF or a WE-EF authorized
agent.
head retention screw X .
secure by tightening screw s D (not KTX) and the
Return head of luminaire B to bollard post C and 8)
= 1-10V control line).
Earthing, DA/DA = DALI control line, D-/D+
1-10V/DALI (L = Phase, N = Neutral, = b)
Earthing)
ON/OFF (L = Phase, N = Neutral, = a)
the terminal block:
Wiring is as follows and should match the labels on 7)
junction box J (not supplied) as per Fig. 3 .
and must be connected via a compliant IP67
clamp H . Note : The KTX does not have t he gear tray
the underside of the head B, and is secured by the
supply terminal block located on the gear tray G on
As per Fig. 2 Connect luminaire cable I to mains 6)
the head retention screw X is positioned.
on KTX) . Note that the rear of the bollard is where
the base with retention bolts D (base is integrated
and tightening bolts G and the post C is attached to
Set cast base F in position and secure by inserting 5)
(see previous page)
.
rotating it anti-clockwise until it can be lifted up
after loosening screw
X
with
a
Torx T-20 tool and
Remove head of luminaire B from bollard post C
4)
mains cable length are provided.
(QVXUHWKDWDVROLGIRXQGDWLRQDVZHOODVVXIƂFLHQW
A suitable recess to be provided for planted root A .
3)
conforms with mains electrical supply.
Check that rating shown on luminaire label
2)
Switch off
and isolate the
mains electrical supply.
1)
maximum stability.
incorporate the optional planted root to ensure
to an even surface, however it is recommended to
The luminaire is suitable for installation directly on
Installation Procedure
)
DC (+ = Positive, - = Negative) c
6