4
Version 2: August 4, 2020
Step 3
– Remove the nuts off the three bolts holding the corner stacking brackets in place on left end as facing the front.
Leave the top two bolts in holes as these will secure the end of unit when raised. Remove the bottom nut and bolt for use
later. The nuts will be replaced on bolts to secure the end sections and corner brackets to the frame when ends are raised
vertically.
Step 4
– First, loosen the nut on the corner pivot bolt.
With transport bolts and the 3 bolts from each corner bracket removed, raise one end of the dumpster ends and attach the
corner post and corner bracket to the frame with the bolts in top two holes from step 3. Before tightening the corner bolts,
make sure that the bottom holes line up for the bag support rod.
Tighten the 2 corner post bolts and
finger tighten only the pivot bolt
loosened earlier. * Make sure your battery is fully
charged when beginning assembly. Have a spare battery available.
Left image shows three
bolts securing end unit
for shipping.
Right image shows top
two nuts removed and
bottom nut and bolt
removed.
Corner Pivot Bolt
–
Loosen
to raise end units.
Use one of the bag support
rods or a screwdriver to
align bag support rod holes.
