wibenchmfg.com
507 E. Grant St. Thorp, WI 54771 • P - 800.242.2303
Specifications are subject to change. Product
images are for illustrative purposes only and may
differ from the actual product.
4
Neck holders
(shown in red)
Side panels
(shown in yellow)
(Right)
(Left)
Support rail
(upper, shown in
purple)
Step 4:
•
Align the threaded insert in the (lower)
neck holder
with the pre-drilled hole in the (lower)
support rail.
.
Using a 1/4”-20x1 3/4” joint connector bolt, insert
the bolt going through the pre-drilled hole to the threaded insert. Use a 4mm Allen wrench or 4mm hex bit and a screw gun to fasten the bolt into place.
Repeat for the remaining bolts.
•
Repeat this step for the (upper)
neck holder
and (upper)
support rail
.
Step 5:
•
Align the threaded insert in the (lower)
neck holder
with the pre-drilled hole in the (right)
side panel.
Using a 1/4”-20x1 3/4” joint connector bolt, insert the
bolt going through the pre-drilled hole to the threaded insert. Use a 4mm Allen wrench or 4mm hex bit and a screw gun to fasten the bolt into place.
•
After the (lower)
neck holder
is attached to the (right)
side panel
, repeat for (left)
side panel
.
•
Repeat this step for the (upper)
neck holder
.
NOTE:
Parts shown in grey are assembled in previous steps.
NOTE:
Colored images are for illustrative purposes only.
Assembly Instructions
Viola/Violin Rack
Support rail
(lower, shown in
blue)
Red dots show the location
where the joint connector
bolts are to be used in this
step.