3
wibenchmfg.com
507 E. Grant St. Thorp, WI 54771 • P - 800.242.2303
Specifications are subject to change. Product
images are for illustrative purposes only and may
differ from the actual product.
Rhapsody® Bass Racks
Assembly Instructions
Step 4:
• Align the pre-drilled holes in the
neck holder
with the
threaded inserts in the (upper)
back support rail.
• Using a 1/4”-20x20mm joint connector bolt, insert the bolt
going through the pre-drilled hole in the
neck holder
to
the threaded inserts of the (upper)
back support rail
. Use
a 4mm Allen wrench or 4mm hex bit and a screw gun to
fasten the bolt into place. You will repeat this step for the
remaining joint connector bolts.
• The holes in the
side panels
and the threaded inserts in
the
neck holder
should already be aligned.
• Using a 1/4”-20x20mm joint connector bolt, insert the bolt
going through the pre-drilled hole in the (right)
side panel
to the threaded insert of the
neck holder
. Use a 4mm Allen
wrench or 4mm hex bit and a screw gun to fasten the bolt
into place.
• Repeat this step to attach the
neck holder
to the (left)
side
panel.
Step 5:
• Align the pre-drilled holes in the
bottom support rail
with
the threaded inserts in the (lower)
back support rail.
• Using a 1/4”-20x20mm joint connector bolt, insert the bolt
going through the pre-drilled hole in the
bottom support
rail
to the threaded insert of the (lower)
back support rail
.
Use a 4mm Allen wrench or 4mm hex bit and a screw gun
to fasten the bolt into place. Repeat for the remaining joint
connector bolts.
• The holes in the
side panels
and the threaded inserts in
the
bottom support rail
should already be aligned.
• Using a 1/4”-20x20mm joint connector bolt, insert the bolt
going through the pre-drilled hole in the
bottom support rail
to the threaded insert of the (right)
side panel
. Use a 4mm
Allen wrench or 4mm hex bit and a screw gun to fasten the
bolt into place.
• Repeat this step to attach the
bottom support rail
to the
(left)
side panel.
(Upper)
Back support rails
(shown in orange)
Neck holder
(shown in green)
Bottom support rail
(shown in blue)
Side panel
(shown in
yellow)
(Left)
(Right)
NOTE:
Parts shown in grey have been assembled in previous steps.
NOTE:
Colored images are for illustrative purposes only.
Step 4
Step 5
