2
wibenchmfg.com
507 E. Grant St. Thorp, WI 54771 • P - 800.242.2303
Specifications are subject to change. Product
images are for illustrative purposes only and may
differ from the actual product.
Step 3:
• Align the pre-drilled holes in the (lower)
back support rail
with the threaded inserts in the (right)
side panel.
Using a 1/4”-20x20mm joint connector
bolt, insert the bolt going through the pre-drilled hole in the (right)
side panel
to the threaded inserts of the (lower)
back support rail
. Use a 4mm Allen
wrench or 4mm hex bit and a screw gun to fasten the bolt into place. You will repeat this step for the other joint connector bolt.
• After the first
back support rail
is attached on one side, repeat for the (left)
side panel.
• Repeat this step for the (upper)
back support rail
.
Rhapsody® Bass Racks
Assembly Instructions
Back support rails
(shown in orange)
Side panel
(shown in
yellow)
(Upper)
(Lower)
(Right)
(Left)
NOTE:
Parts shown in grey have been assembled in previous steps.
NOTE:
Colored images are for illustrative purposes only.
