- 19 -
6�4 Disassembly of transducer
Before dismantling, remove transducer from the cylinder (see chapter installation).
Loosen 16 pcs. main housing screws and take 14 pcs. completely out.
Leave 2 pcs. opposite wise lightly tightened.
Loosen 4 pcs. spring housing screws with holding the spring housing against
the spring torque. Turn back the spring set and pull out the wire rope of the
transducer at the same time.
Note:
Only by transducer specific trained persons. The stored energy of the spring may
lead to injuries when being mishandled.
As soon as the wire rope is completely pulled out, the springs can be turned back
to zero torque. Remove spring set with holding back the center spring hook to
avoid a uncontrollable spring roll off.
Note:
Only by transducer specific trained persons. The stored energy of the spring
may lead to injuries when being mishandled. Sufficient energy is stored into the
spring even if the spring set is turned to zero torque.
Remove encoder (see chapter 6.2). Loosen 2 screws of the encoder adapter and
remove it in axial direction.
Note:
Do not bend or apply radial force to the rotation shaft and encoder adapter. The
rotation shaft and seal could be damaged.
Remove the last 2 screws from the main housing. Remove the main housing cap
in axial direction without tilt. Remove the o-ring.
Note:
The main housing cap must not be cant. Be aware of the rotation shaft and do
not apply radial force to the shaft. The rotation shaft and seal could be damaged.
6 MAINTENACE AND SERVICE
