D Mode CT
FCC DRAFT
3
Copyright © 2004 Waxess
2 Plug the telephone line cord to the TEL LINE jack and the AC
adaptor to the DC IN 9V jack.
3 Wrap the AC adaptor inside the molded wiring channel(?), then
wrap the cord around the strain relief notch (?)
4 Raise the antennas to a vertical position.
5 Align the mounting slots on the base with the screws in the
wall. Then push in and down until the phone is firmly seated.
6 Connect the handset cord to the jacks on the handset and
base, then set the handset in the cradle.
7 Handset retainer??
Note:
Go to “Power on” on page ?? before connecting power.
Ready the wireless handset
INSTALL THE BATTERY
1 Open the cover.
2 Connect the battery.
3 Close the cover
CHARGE THE BATTERY
1 Connect the AC adaptor to the DC 9V IN jack on the charger
and to a standard 120V AC wall outlet.
2 Set the charger on a desk or tabletop, then set the handset in
the charger with the keypad facing forward.
3 Allow the battery to charge for 12–15 hours.
Base unit power on
When powered on for the first time, the
base unit goes through an initialization
sequence.
When the sequence is complete, this
screen appears.
If you have made a connection with
your cellular service provider, the date
and time may be set automatically. If
not, refer to the next section to set the
date and time manually.
00:00A 01/01
?
Base
Initializing
12:34A 12/23
?
TEL
NEW
: 00
TOTAL : 00
CEL
