D mode CT
FCC DRAFT
2
Copyright © 2004 Waxess
Desk or Tabletop
1 Connect the telephone line cord to the TEL LINE jack and to a
telephone outlet.
2 Set the base unit on a desk or table top and place the handset
on the base unit.
3 Connect the handset cord to the jacks on the handset and
base, then set the handset in the cradle.
4 Raise both antennas to a vertical position.
5 Connect the AC adaptor to the DC IN 9V jack.
Note:
Go to “Power on” on page?? before connecting power.
Wall mount
WITH STANDARD WALL PLATE
1 Wall mount adaptor needed?
2 Plug the telephone line cord to the TEL LINE jack and the AC
adaptor to the DC IN 9V jack.
3 Wrap the AC adaptor inside the molded wiring channel(?), then
wrap the cord around the strain relief notch (?)
4 Raise the antennas to a vertical position.
5 Align the mounting slots on the base with the mounting posts
on the wall plate. Then push in and down until the phone is
firmly seated.
6 Connect the handset cord to the jacks on the handset and
base, then set the handset in the cradle.
7 Handset retainer??
Note:
Go to “Power on” on page?? before connecting power.
WITHOUT WALL PLATE
If you do not have a standard wall plate you can mount the phone
directly to a wall.
Important considerations:
• Avoid electrical cables, pipes, or other items behind the
mounting location that could cause a hazard when inserting
screws into the wall.
• Mount your phone within 10 - 15 feet of a working phone jack
to avoid excessive cord lengths.
• Verify that the wall material can support the weight of the
handset and base unit.
• Use screws and anchoring devices suitable for the wall
material where you place the base unit.
1 Insert two mounting screws along with the correct anchoring
devices? 0?/? inches apart. Leave about ?/? of an inch between
the wall material and the screw heads for mounting the phone.
