Wavin Temp Manifold Installation Manual
ower
www.wavincom
.
TELEPHONE
+31(38)429411
Design Manual
TELEPHONE
+31 (38) 4294911
4
www.wavin.com
4
Wavin Temp Control Manual
ower
www.wavincom
.
TELEPHONE
+31(38)429411
2
2.. S
Sa
affe
etty
y
The following information is intended to help you throughout the
entire documentation.
We accept no liability for any damage caused by non observance
of these instructions.
2
2..1
1 G
Ge
en
ne
erra
all rre
ec
co
om
mm
me
en
nd
da
attiio
on
ns
s
Installation must be installed by a suitably qualified
engineer, who is responsible for observing all relevant
standards and regulations
Only make changes or modifications as specified in
this manual.
Power must be switched off when installing the
wiring.
The Wavin Control System uses a 230VAC 50Hz power
supply.
In case of emergency, immediately disconnect the plug
from the 230V mains.
Do not use water to clean the Wavin Control System.
Do not expose the Wavin Control System to flammable
vapours or gases.
Keep installation/data cables away from power cables >
50V to avoid interference.
The electrical circuits of the boiler and the pump must
be protected by a maximum 6A circuit-breaker.
Design Manual
Heating and Cooling systems
Design Manual
Heating and Cooling systems
Design Manual
Heating and Cooling systems
Design Manual
Heating and Cooling systems
Design Manual
Heating and Cooling systems
Design Manual
Heating and Cooling systems
Design Manual
Heating and Cooling systems
Design Manual
Heating and Cooling systems
Design Manual
Heating and Cooling systems
