Wavetronix Click 500 Series, User Manual

Page: 69 / 109

68
CHAPTER 7
• CLICK 512
Location
Displays the location of the device being configured. This is only for
your information and does not affect the operation of the device.
Serial Number
Displays the serial number of your device.
Firmware Version
Shows the version of firmware your device currently has installed. If
Click Supervisor detects a discrepancy between this version and the
most current version it currently has access to, you will be prompted
to upgrade when you connect to the device.
Subnet ID
Shows the subnet ID number. This option is currently not available.
Device ID
Gives the ID number of the device being configured, which is used
to identify the device when you are connecting to it. By default, this
number is the last five digits of the serial number, which can be found
under the About tab or on the barcode sticker on the bottom of the
device. It is recommended that you do not change this number unless
another device on the network has the same ID number.
Table 7.2 – Expert Driver General Tab
The
Comm
subtab allows you to configure how the Click device communicates (see Figure
9.1010 and Table 9.3).
Figure 7.10 – Expert Driver Comm Tab
Setting Description
Baud Rate
Allows you to change the baud rate at which the device listens for
data pushed from the SmartSensor HD. It also changes the baud rate
in serial convertor mode. It does not affect the baud rate for Click
Supervisor communications or data forwarding, which are always at
9600 bps. It does not affect the baud rate of communications with a
Click 104/112/114.
Flow Control
Is used for configuring hardware handshaking. This option is currently
not available.