Waves CA3000-MX / User Guide
6
Setup Guide
Follow these steps to prepare the CA3000-MX for operation in an AV installation with an ASIO interface or Dante
network audio.
H
ARDWARE
C
ONNECTIONS
1. Connect the power cables to mains. For the computer and all devices use the enclosed power cables.
2. Connect the keyboard and mouse (used for CA3000-MX setup and configuration).
3. Connect up to two displays to the video ports. There is one HDMI port and one DisplayPort.
4. Connecting the CA3000-MX to a Dante network: Connect one of the LAN Ethernet ports to the switch on the
Dante audio network. The EtherCON connector is the factory-configured Dante network port. This port assignment
can be changed in the Dante Virtual Soundcard (DVS) configuration window.
Note: DVS is configured at the factory as the selected Device on the System Inventory page in the eMotion LV1
Setup tab.
5. Connecting the CA3000-MX to an ASIO interface: Connect the ASIO interface to one of the USB connectors on
the CA3000-MX. Follow instructions provided by the interface manufacturer to install and configure the ASIO
driver on the CA3000-MX.
Note: DVS is configured at the factory as the selected Device on the System Inventory page in the eMotion LV1
Setup tab. If using an ASIO device, the corresponding device driver must be selected after installing the ASIO
interface.
W
AVES
CA3000-MX
S
OFTWARE
The Waves CA3000-MX comes with the software activated and is ready to use. The following applications are
included with the Waves CA3000-MX system:
•
Waves LV1 Native (install-ready version of eMotion LV1)
•
Audinate Dante Virtual Soundcard (DVS)
Waves eMo plugins (D5, F2, Q4, Generator) are installed and activated on the CA3000-MX.
