Operation Of Key Pads
1. The unit will beep twice once plugged into the power socket.
2. Press the “ON/OFF” button to turn on the unit. The deflector will startup automatically and at this point,
the unit is in the status of constant dehumidifying and high speed running.
1
）
The blue backlight will illuminate and turn off after 15 second.
2
）
The LCD display shows the working mode and status of unit.
3
）
The LCD display shows the ambient humidity and temperature.
4) Press the “ON/OFF” button again, the unit will stop working and the deflector close.
3. MODE:
Set up continuous & automatic dehumidifying modes and air speed by using the MODE key. Select or
change to the desired mode (the indicator light will illuminate accordingly), then press “Setting” to
change the running mode and automatic dehumidifying ratio.
(1) When the automatic dehumidification indicator illuminates, press “Setting” to make it
circulate among 60%RH-65%RH-70%RH-75%RH-80%RH-40%RH-45%RH-50%RH-55%RH
-60%RH
·
·
·
·
·
1
）
When entered into automatic dehumidification, if you press “Setting”, the continuous
dehumidifying mode will be cancelled.
2
）
Press “Mode” or three seconds after pressing “Setting”, the desired humidity ratio is set
and the indicator light switches off.
3
）
When sensor detected ambient humidity is 1% lower than your setting, compressor shut
off and fan works at low speed. If ambient humidity is 5% higher than the setting, the
dehumidification is activated again.
(2) When the wind speed
indicator illuminates, press “Setting” to select your desired fan
blower setting of “High speed” level or “Low speed” level.
1) It shows ‘L’ when working at “Low speed” level and shows ‘H’ when working at “High
speed” level.
2) Press “Mode” or three seconds after pressing “Setting”, the wind speed is set.
3) When the wind speed is set, dynamic patterns rotate.
4) When the sensor detects that the ambient humidity is lower than your desired setting, the
fan works at low speed.
5) When the sensor detects that the ambient temperature exceeds 32
°
C, the fan works at
the “High speed” level automatically.
（
3
）
When the continuous dehumidification indicator illuminates, press “Setting” to make the
unit run at the continuous dehumidification mode.
4. SETTING
：
When the indicator light illuminates according to your desired mode, pressing “Setting” will confirm the
running mode or automatic dehumidifying ratio.
