Wavelength Electronics LAB Series, Manual

Page: 1 / 27

VIRTUAL INSTRUMENT
Remote Control of LAB Series Instruments
QCL LAB, TC LAB, LDTC LAB
TABLE OF CONTENTS
COMPUTER SPECIFICATIONS 1
OPERATING INSTRUCTIONS - QC LAB 2
OPERATING INSTRUCTIONS - TC LAB 6
OPERATING INSTRUCTIONS - LDTC LAB 14
ADDITIONAL TECHNICAL INFORMATION 25
TROUBLESHOOTING 26
WARRANTY & CERTIFICATION
27
Applies to Revision 1
© October 2019
406-587-4910
www.teamWavelength.com
COMPUTER SYSTEM REQUIREMENTS
Windows Operating System Compatibility
Windows 10/8.1/8/7 SP1 (32- and 64-bit)
Windows Server 2012 R2 (64-bit)
Windows Server 2008 R2 SP1 (64-bit)
Processor
Pentium III/Celeron 866 MHz (or equivalent) or later (32-bit)
Pentium 4 G1 (or equivalent) or later (64-bit)
RAM 256 MB minimum
Screen Resolution 1024 x 768 pixels
Disk Space
5 GB available hard disk space (32-bit)
20 GB DirectX 9 graphics device with WDDM 1.0 or higher driver (64-bit)
Installation Prerequisites
NI LabVIEW
®
-OR-
NI Runtime Engine for 2015, SP1 - 32 bit (2017, 64 bit for LDTC LAB)
NI-VISA Device Drivers
COMPUTER SPECIFICATIONS
e
REMOTE INSTRUMENT CONTROL
Wavelength's Virtual Instruments offer higher level remote
control based on the Command Set for these TMC class
instruments. See the LAB Series Instrument Command Set
document for lower level control.
These free applications are executable files that use the
National Instruments Run Time Engine.
One of each type of instrument can be operated at a time.
If you would like different default values or functionality,
or the full VI, contact Technical Support. Custom Virtual
Instruments can easily be coded.