4.3. Spa cover and security
After each use, the control panel must be locked and the spa must be covered with
its top cover and it must be attached to the base protector with the safety buckles.
Each safety buckle has a lock system; To close the buckle, put the latch in an up
position which locks the buckle, Put the latch in a down position to unlock the
buckle.
The top cover retains the heat from the water and secures the spa.
4. USAGE
EN
11
4. USAGE
4.1. Control panel
4.2. Functions
WIFI Button
Temperature Increase
Button
Fahrenheit Degree
ON/OFF
LED Display
Centigrade Degree
Temperature Decrease
Button
Once powered-up, the LED displays the current water temperature automatically.
The temperature units selector changes the temperature units from Centigrade
degrees to Fahrenheit degrees.
Press the temperature adjustment buttons, then the screen will flash. When it is
flashing, you can set the desired temperature. The value will increase or decrease
1 degree at once. If you keep pressing the “+” or “-” for more than 2 seconds, the
value of the digital tube will increase or decrease rapidly at a frequency of 5/sec. The
temperature could be set between 30°C to 40°C (86°F to 104°F).
To lock or unlock the control panel, press the Lock button and hold 3 seconds. Lock
the control panel when you are away to prevent other people come to change your
settings.
Press the massage button to activate the bubble massage system, the green indicator
light turns on. It can be turned off by pressing it again.
Note:
- The massage system will stop automatically after 30 minutes of operation.
Re-activate the massage function by pressing the massage button again.
- When filter button is on, pressing bubble button will exchange filter mode into
massage mode: filter massage mode will be changed back to filter mode.
Press the filter button to activate the water filtration. The green indicator light will turn
on when the filtration system is activated.
Note:
- If massage function is on, the filtration can’t be activated.
Press the heating button to activate water heating and filtering system at the same
time. The green indicator light of filter and red indicator light of heating will turn on the
same time.
The pump does not stop heating until the current water temperature reaches the set
temperature; and the heating system will restart after the current water temperature
drops 2°C below the set temperature automatically. Maximum heating temperature:
40°C (104°F)
Important:
After 150 cumulative hours of filtration operations, an audible alarm will sound
and the LCD display will show the characters CHG, followed by FIL, to remind you
to change or clean the filter. You can hold the filtering button 5 second to turn off
the buzzing. The filtering system will turn off, you can press the button to active
the filtering system again.
Note:
- With heating system starting, the filtration system will start working together.
- After turning off the heating system, the filtration system will still work.
- If massage function is active, the filtration and heating functions can not be activated.
1. Choose the function
2. Press the reservation button
3. Start reserving the time
4. Digital flashing display 0.5H and press ‘+’ and ‘-’ to adjust. If you keep pressing the “+”
or “-” for more than 2 seconds, the reservation time will increase or decrease rapidly.
5. Press the reservation button again or no operation for five seconds, setup will be
completed.
Adjust the reservation function
In the reservation state, short press the reservation button to enter the reservation time
setting state.
Cancel the reservation function.
In the reservation state, press and hold the reservation button for 5 seconds to cancel
the reservation state and enter the standby state
