TROUBLESHOOTING
Load will not turn ON:
• LED does not flash:
‑ Check the sensitivity for proper
configuration.
‑ Check all wire connections. Verify the
ground wire is tightly secured.
• LED does flash:
‑ Press the ON/OFF button. If load does not
turn ON, check all wire
connections and verify the load wire is
tightly secured.
‑ Check the light level trimpot.
‑ If light level feature is desired, follow the steps from the Sensor
Adjustment.
‑ If light level feature is not desired, turn trimpot fully clockwise to
disable.
• If load still does not turn ON, call 800.879.8585 for technical support.
Load will not turn OFF:
• The time delay can be set for 30 seconds (Walk Test), 5, 10, 15, 20, 25, or 30
minutes. Ensure that the time delay is set to the desired delay and that there
is no movement within the sensor’s view for that time period.
• To quickly test the unit for proper operation, turn the time delay to minimum
(fully counterclockwise) and move out of the sensor’s view. Load should turn
OFF after 30 seconds.
• If load still does not turn OFF, call
800. 879.8585 for technical support.
Sensing motion outside desired area:
• Opaque adhesive tape is included with the sensor and can be used to limit the
detection areas. See Masking the Lens.
• Adjust sensitivity counterclockwise to reduce excessive sensitivity.
Call 800.879.8585 for Technical Support
Sensitivity
(S)
shown as set
for Maximum
Light Level
(L)
shown as set
for Maximum (+)
to disable
Time Delay
(T)
Shown as set for
15 minutes
Time Delay
(T)
Shown as set for
15 minutes
30 seconds
(Walk-test)
5 minutes
10 minutes
20 minutes
25 minutes
30 minutes
L
T
S
