SENSOR ADJUSTMENT & PROGRAMMING
The WN-100 is designed for installation in hotel rooms and other semi-public
spaces. Custom setup features are intended for facility or installing personnel
only. Therefore, the Program Mode switch is located behind the cover plate. To
enable the Programming mode, the single DIP switch must be in the ON
(Program) position.
Programming the WN-100:
1. Slide the Program Mode switch (normally
covered by the light switch cover plate) to
the ON (Program) position. The nightlight
will flash, counting out the selected
operating mode (one flash then a pause =
mode 1, two flashes then a pause = mode
2, and so on)
2. Press the ON/OFF button to advance
through the modes. When you reach the
desired mode, slide the Program Mode
switch to the DOWN (End User) position.
3. When the Program Mode switch is returned
to the DOWN (End User) position, the
WN-100 will operate in Test Mode for five
(5) minutes. During this period, the time
delay will be 15 seconds and the WN-100
will operate as “Automatic-ON”. After five
(5) minutes, the WN-100 will use the
parameters of the selected mode.
Note:
Do not leave the Program Mode Switch in the UP (Program) position. The
WN-100 will only operate properly in the DOWN (End User) position.
Mode Selections:
Flashes
Time Delay
Mode
R
1 hour *
Manual-On
* Factory default
RR
2 hours
Manual-On
RRR
30 minutes
Manual-On
RRRR
15 minutes
Manual-On
RRRRR
15 minutes
Automatic-On
End User Options:
To disable the nightlight, press and hold the ON/OFF button. After one-half
second, the nightlight will display the Enabled/Disabled status (lit = nightlight
enabled, unlit = nightlight disabled). To change the status, continue to press and
hold the ON/OFF button. After five (5) seconds, the WN-100 changes state (for
more details, see “Nightlight” in the Operation section).
TOP
ON
1
INDOOR USE ONLY
TOP
ON
1
INDOOR USE ONLY
WN-100
Program
Mode
Switch
Nightlight
glows
behind lens
ON/OFF
Button
