ReSet pRoceSS
Load binding reset -
To clear the unit so that it is not bound to any load:
1 . Do not point the LMRH-101 toward any DLM IR enabled device .
2 . Press and hold the configuration button in the battery compartment until
the red LED goes solid ON (approximately 10 seconds) .
Device reset -
To get the unit back to its default Plug n’ Go state (bind to all
loads):
1 . Do not point the LMRH-101 toward any DLM IR enabled device .
2 . Press and hold the configuration button in the battery compartment for
20 seconds .
System Reset -
This reset returns ALL DLM devices to their factory default
PnG settings . All system settings will be reset; all customized binding
relationships will be lost . All PnG functionality will be restored . To return
all devices on the DLM local network to PnG using the LMRH-101:
1 . Point the LMRH-101 at an IR enabled DLM local network device .
2 . Press and hold the configuration button in the battery compartment until
the red LED starts blinking to put the DLM local network into PnL (see
Step 1 in UNIT ADJUSTMENT for details) . Release the button .
3 . Press and hold the configuration button again for approximately 20 seconds,
until the red LED on the DLM devices resume blinking rapidly (approximately
2x/second) .
tRoUBLeSHootinG
LeD on the
remote
doesn’t
light
Press the button . If the LED doesn’t light:
• Check to see if the LED is actually lit, but very dim.
This is normal . Press the top of the button to fully
turn ON the LED .
• Check batteries. Replace if needed.
•
Remove the batteries for 5 minutes . After 5 minutes,
reinstall the batteries and try again .
Please
Recycle
2800 De La Cruz Boulevard, Santa Clara, CA 95050
Technical Support: 800.879.8585 • www.wattstopper.com
Please
Recycle
2800 De La Cruz Boulevard, Santa Clara, CA 95050
Technical Support: 800.879.8585 • www.wattstopper.com
12512r2 7/2010
