Unit aDJUStMent
A “configuration” button allows access to the
WattStopper Push n’ Learn™ technology to
change the operation of the LMRH-101 .
Step 1: enter push n’ Learn (pnL)
a . Locate the configuration button inside the
LMRH-101 battery compartment .
b . Point the LMRH-101 at a DLM IR device .
c . Press and hold the configuration button
until the red LED in the battery compartment begins blinking
(approximately 3 seconds), then release the button . Make sure the
LMRH-101’s red LED continues to blink, then observe the following:
- The Red LEDs on all other DLM devices on the network start blinking
rapidly (2x/second) . The LEDs continue to blink until you exit PnL .
- All loads on the DLM local network turn OFF immediately after entering
PnL . After 1 second, load 1 turns ON .
Step 2: Load Selection
A quick press on the LMRH-101’s configuration button turns OFF load 1
then turns on the next load in sequence . Keep pressing the configuration
button to step through all the loads connected to the DLM local network .
When a load turns ON the blue LED is lit brightly on all switch buttons and
sensors bound to the load .
- To bind the load to the LMRH-101: While the load is ON press the
paddle making sure that the blue LED turns ON brightly .
- To unbind a load: While the load is ON and the blue LED is brightly
lit, press the paddle . The LED goes dim to indicate the paddle on the
handheld remote no longer controls this load .
- A quick press on the configuration button turns ON the next load .
- Repeat until the paddle is bound to all the loads you want it to control .
note:
more than one load can be assigned to the paddle and a load can
be assigned to multiple devices in the DLM network .
Step 3: exit push n’ Learn (pnL)
a . Point the LMRH-101 at a DLM IR device .
b . Press and hold the LMRH-101 configuration button until the red LED
in the battery compartment stops blinking (approximately 3 seconds),
then release the button .
Point at
DLM Device
Configuration
Button
Red LED
