Turn off the cold water supply to the faucet by
turning the angle stop valve completely off.
Attach the adapt-a-valve as illustrated in the
three photos above, choosing the configuration
that fits your plumbing.
Configuration for 3/8”
compression fittings
Configuration for 1/2”
compression fittings
Hot
Supply
Cold
Supply
Brass Valve Configuration:
Step 6
Step 7
How to use the Quick Connect Fittings on Your RO System
To make a connection, the tube is simply pushed into the
fitting. The unique locking system holds the tube firmly in
place without deforming it or restricting flow. Use the steps
below in reference to any quick connect tube connections
throughout this manual.
It is essential that the outside diameter be free of score
marks and that burrs and sharp edges be removed before
inserting into fitting.
Fitting grips before it seals. Ensure tube is pushed into the
tube stop.
Push the tube into the fitting, to the tube stop. The collet
(gripper) has stainless steel teeth which hold the tube
firmly in position while the O-ring provides a permanent
leak proof seal.
Pull on the tube to check that it is secure. It is a good
practice to test the system prior to leaving site and /or
before use.
To disconnect, ensure the system is
depressurized before removing the tube. Push in the
collect squarely against face of fitting. With the collet held
in this position, the tube can be removed. The fitting can
then be reused.
Feed Water Valve Installation Continued
Turn off the cold water supply to the faucet by
turning the angle stop valve completely off.
Attach the adapt-a-valve as illustrated in the
three photos above, choosing the configuration
that fits your plumbing.
Configuration for 3/8”
compression fittings
Configuration for 1/2”
compression fittings
Hot
Supply
Cold
Supply
Brass Valve Configuration:
Step 6
Step 7
How to use the Quick Connect Fittings on Your RO System
To make a connection, the tube is simply pushed into the
fitting. The unique locking system holds the tube firmly in
place without deforming it or restricting flow. Use the steps
below in reference to any quick connect tube connections
throughout this manual.
It is essential that the outside diameter be free of score
marks and that burrs and sharp edges be removed before
inserting into fitting.
Fitting grips before it seals. Ensure tube is pushed into the
tube stop.
Push the tube into the fitting, to the tube stop. The collet
(gripper) has stainless steel teeth which hold the tube
firmly in position while the O-ring provides a permanent
leak proof seal.
Pull on the tube to check that it is secure. It is a good
practice to test the system prior to leaving site and /or
before use.
To disconnect, ensure the system is
depressurized before removing the tube. Push in the
collect squarely against face of fitting. With the collet held
in this position, the tube can be removed. The fitting can
then be reused.
Feed Water Valve Installation Continued
Summary of Contents for FMRO4G-ERP-75
Page 19: ......
