Standards
– Watts WaterPEX
®
CinchClamps are manufactured in accor-
dance with American Society for Testing and Materials
(ASTM) F-2098.
– Watts WaterPEX
®
Fittings are to be manufactured in accor-
dance with American Society for Testing and Materials
(ASTM) F-1807, F-2159, and F-2434.
– Only for use with PEX manufactured to ASTM F-876/F-877
Holster
Manual
CinchClamp™ Tool
Gauge
Calibration Bar
Manual CinchClamp™ Tool with work pouch and calibration gauge.
Calibration gauge and calibration bar are located in side pouch.
Gauge and
Calibration
Bar Pouch
For Residential and Commercial Applications
ES-WP-WPCCT-2
Job Name –––––––––––––––––––––––––––––––––––––––––––
Contractor ––––––––––––––––––––––––––––––––––––––––––––
Job Location –––––––––––––––––––––––––––––––––––––––––
Approval –––––––––––––––––––––––––––––––––––––––––––––
Engineer –––––––––––––––––––––––––––––––––––––––––––––
Contractor’s P.O. No. –––––––––––––––––––––––––––––––––––
Approval –––––––––––––––––––––––––––––––––––––––––––––
Representative ––––––––––––––––––––––––––––––––––––––––
Model WPCCT-2
Manual CinchClamp™ Tool
Sizes:
3
⁄
8
",
1
⁄
2
",
5
⁄
8
",
3
⁄
4
" (10, 15, 18, 20mm)
The Watts Manual CinchClamp™ Tool is designed for use with
tubing and CinchClamp™ connections.
Specifications
Connections shall use Watts brass and poly-alloy crimp
fittings and Watts WaterPEX
®
cross-linked polyethylene pipe.
Installation
All CinchClamps must be installed using a Watts CinchClamp
Tool and in accordance with all installation guidelines.
– Make sure the Watts WaterPEX
®
has a clean, square cut end.
– Slide the CinchClamp over the Watts WaterPEX
®
.
– Insert fitting and position CinchClamp, allowing for
approximately
1
⁄
8
" clearance between clamp and fitting.
– Position the open jaws of the Manual CinchClamp Tool over
the tabs of the CinchClamp and squeeze.
Tool will release
when cinch is complete.
If connections are made in temperatures below 30°F,
caution must be taken to cinch slowly between ratchets,
allowing the Watts WaterPEX
®
to form a proper seal
against the barb.
Do not use the Manual CinchClamp Tool to remove
CinchClamps. This will cause damage to the tool, result-
ing in improper connections.
Model
desCriPTion
WPCCT-2
Manual CinchClamp™ Tool
Watts product specifications in U.S. customary units and metric are approximate and are provided for reference only. For precise measurements,
please contact Watts Technical Service. Watts reserves the right to change or modify product design, construction, specifications, or materials with-
out prior notice and without incurring any obligation to make such changes and modifications on Watts products previously or subsequently sold.
